|
| |
Pre-wired Velocity
Systems
Call Velocity's Parts
department at (772)589-1860 for orders.
All prices are subject
to change without notice. Please call the factory first to determine current
prices.
| Pre-Wired
RG System
 
|
| Pre-wired
gear system with all current mods, includes all wiring, switches, and
circuit breakers, and a complete installation manual. ( Note: price
reflects an upgrade from items included with the basic kit, pump not
included. See details.) |
$975.00 |
| |
| XL Power Panel
|
Upper switch panel is pre-wired to
circuit breaker panel. Circuit breaker panel comes with 26 pull to
disengage circuit breakers on a pre-marked easy to install panel with
power relays, filters and avionics circuits.
|
$1820.00 |
| |
| Standard Power
Panel
|
| The
Standard power panel is a self-contained power distribution assembly. The
panel includes most of the commonly used switches and circuit breakers as
well as a split master switch. There are 8 accessory switches and 18
circuit breakers. Panel dimensions
2.25" high x 13" wide x 7.5" deep |
$618.00 |
| |
Standard Upper Switch
Panel |
Fits overhead Standard
Panel |
$85.00 |
| |
| Power Gaurd Module
|
The power guard module manages
fail safe secondary power control for aircraft that require backup
electrical power. This can keep systems like EFIS screens and electronic
ignitions operational during aircraft starting. |
$91.00 |
Trim relay board |
to be used with china
hat switch |
$124.00 |
| |
Annuciator board |
Press to test panel |
$135.00 |
| |
| XL or Standard Wiring
harness
|
| The
Velocity wiring harness includes most if not all of the primary wire
required for a typical aircraft. Included in the harness are the primary
power runs for the battery , starter, alternator, master and starter
solenoids. Power distribution for the fuel pump, navigation, strobe,
landing and cabin lights, pitot heat and alternator field are also
supplied. Additional wiring in the harness is provided for left &
right magneto/ ignition , left/right fuel gauges, low fuel sump, hobbs,
fuel pressure, low fuel pressure, oil pressure, low oil pressure, oil
temp, low oil level, spare wires, roll trim wires, mater and starter
solenoid controls and fused keep alive for radio's or clock. All wires are
are labeled at each end for easy identification. Two labeled terminal
strips also come with the system. All wiring for control and power has
been designed to be used with the velocity power panels listed above. All
wiring for the control and power has been suitably terminated with ring
terminals, cut to exact length, to fit between the power panel and the
terminal blocks as specified. |
$1350.00 |
|
| |
|
|
|